接通水

Turn on the water

扣動噴槍桿上的扳機排除設備內的水或氣。

Pull the trigger on the spray gun rod to remove water or air from the equipment.

將設備電源開關處于開位置，扣動槍柄扳機即可。

Turn the power switch of the equipment to the on position and pull the trigger of the gun handle.

釋放噴槍扳機，并將扳機設置在鎖定位置，關閉電源開關，按上噴嘴。

Release the trigger of the spray gun, set the trigger in the safe lock position, turn off the power switch, and press the nozzle.

扣動噴槍桿上的扳機并保持以釋放在泵里生成的壓力，當轉換到"開"位置時，繼續保持扣動扳機狀態，直噴出的水不帶泡沫為止。

Pull the trigger on the spray gun lever and keep the pressure generated in the pump released. When changing to the "open" position, continue to pull the trigger until the water is out of foam.

將噴槍桿上的噴嘴卸下，這樣做有助于排除泵內的空氣。

Remove the nozzle from the spray gun rod to help remove the air from the pump.

將高壓軟管接在噴槍桿和高壓超聲波清洗設備之間。

Connect the high-pressure hose between the spray gun rod and the high-pressure ultrasonic cleaning equipment.

將橡膠軟管接在供水系統和高壓超聲波清洗設備之間。

Connect rubber hose between water supply system and high pressure ultrasonic cleaning equipment.